NCR S10 - Manual (Page 142)

Sample Configurations
Sample RAID Configuration
C-22 NCR S10 Desktop Server User Guide
Parallel Port [Enabled as LPT1...]
Serial Port 1 [Enabled as Serial 1...]
Serial Port 2 [Enabled as Serial 2...]
System Setting
Special System Ports [Enabled]
EISA Reserved Device [Enabled]
If a PCI adapter is configured in the system,
change Disabled to the IRQ level for the PCI adapter
installed in the slot.
4. Exit and save the configuration.
Prior to installing the operating system, it is necessary
to use the Mylex Disk Array Configuration Utility to
configure the Array Group.
Refer to the Mylex Disk Array Controller User’s Manual
for detailed instructions.
*Note:
Configuring the Mylex
RAID Array Group