NCR S10 User Manual
Page 77
Advertising
Using the BIOS Setup Utility
System Security Setup
NCR S10 Desktop Server User Guide
4-25
unauthorized users. Once you set this password, you
have to type it whenever you boot the system.
To set the power-on password, follow the same
procedures as in setting the setup password.
To enable the password function, you must
strap pins 1-2 on JP2 located on the system baseboard.
The factory default setting disables the password
function with pins 2-3 strapped. See Figure 2-1 in
Chapter 2 for the location of JP2.
Note:
Advertising