Installing a fixed disk drive – NCR S10 User Manual
Page 41
Installing the System
Installing Drives
NCR S10 Desktop Server User Guide
2-23
9.
Plug the power supply cable into the power
connector at the rear of the drive.
The connector is slotted so it fits only in one
direction.
10.
Replace the system top and front covers.
11.
Run Setup to reconfigure the system into a two-
peripheral drive configuration.
When you purchase an fixed disk drive, make sure that
you have all the required cables. Do not forget to obtain
the bad sector information from your dealer.
To install a fixed disk drive, follow these steps:
1.
Remove the drive frame from the system housing.
2.
Insert the first drive into the lower drive bay with
the component side facing down.
3.
Secure the drive with screws on both sides.
4.
Insert the second drive into the upper drive bay
with the component side facing down.
Figure 2-12
Connecting the Drive Cables
Note:
Installing a Fixed Disk
Drive