Nortel Networks Remote Gateway 50 - Manual (Page 173)

Dialing Plan configuration Page 173 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
Special Number. The call-type before digit manipulation is determined as
follows:
• If the call-type before digit manipulation is SPN (Special Number), it is
converted to a value corresponding to the CLTP parameter in the Special
Number Translations data block, as shown in Table 16.
• If the call-type before digit manipulation is not SPN (Special Number),
it is not changed.
CLID verification
Use the CLIDVER prompt in LD 20 (for Release 4.0 and Release 4.5) to
verify that the CLID has been properly composed and configured. This
command simulates a call, without actually making the call, and generates a
report of the properties of the call.
Configuring PSTN access for SRG users in Normal Mode
Preparing to configure the dialing plan
Before configuring the dialing plan for PSTN access to SRG users in Normal
Mode, you must complete the following steps:
• At the main office, configure the Virtual Trunk to enable calls originating
on SRG IP Phones in Normal Mode to reach the branch office. Refer to
IP Peer Networking: Installation and Configuration (553-3001-213) for
details.
• At the main office, configure trunks for access to the PSTN.
Table 16
Mapping between from CLTP parameter in SPN block to call-type before
digit manipulation
CLTP parameter Call-type before digit manipulation
LOCL Local PSTN
NATL National PSTN
INTL International PSTN