Nortel Networks Remote Gateway 50 - Manual (Page 98)

Page 98 of 258 Bandwidth Management
553-3001-207 Standard 2.00 January 2006
Differences when every branch office HLOC is shared with the
main office
Table 7 shows the configuration when the branch office HLOC is shared with
the main office.
Call between two branch offices associated with the same
main office
The following scenarios describe calls between two branch offices that
belong to the same main office. the different scenarios described below vary
vary in the manner in which the HLOC is architected; branch offices have
same HLOC as the main office, branch offices have a different HLOC than
the main office and so on.
Every branch office HLOC is shared with the main office
In the following example, the HLOC of all the branch offices and the HLOC
of the main office are all the same. See Figure 21 on
page 99 .
Table 7
Provisioning details for this case
Region Provisioning detail
1 Provisioning on the main office requires parsing to only
“normal” LOC identification and HLOC deletion.
1 LOC values that are on branch offices may be provisioned as
extended LOCs (> 3 digit codes).
1 The DMI for the branch office “LOC” inserts a gateway routing
prefix in front of the number.
2,3 Similar configuration, as above, applies to regions 2 and 3.