Nortel Networks Remote Gateway 50 - Manual (Page 83)

Bandwidth Management Page 83 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
CHG ZQRTI <Zone> <Interval>
Change the QoS Response Time Interval while alarms are not coming, in
order to increase the Sliding Maximum for the identified zone, where:
• Zone = 1-255
• Interval = interval in minutes = 1-(5)-120
CHG ZQUAT <Zone> <Thres>
Change the QoS Unacceptable Alarm Threshold value for the identified zone,
where:
• Zone = 1-255
• Thres = threshold value = 1-(75)-99
Note: When the zone-to-zone QoS value drops below the threshold value,
the alarm is presented. When the zone-to-zone QoS value is greater than this
threshold value, this alarm is presented as being deactivated. This value must
be below the value of ZQWAT.
CHG ZQWAT <Zone> <Thres>
Change the QoS Warning Alarm Threshold value for the identified zone,
where:
• Zone = 1-255
• Thres = threshold value = 1-(85)-99
Note: When the zone-to-zone QoS value drops below the threshold value,
the alarm is presented. When the zone-to-zone QoS value is greater than this
threshold value, this alarm is presented as being deactivated. The value for
ZQWAT must be higher than the value of ZQUAT.
LD 117 — Configure Adaptive Network Bandwidth Management. (Part 4 of 6)
Command Description