Nortel Networks Remote Gateway 50 - Manual (Page 237)

Emergency Services configuration Page 237 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
Procedure 16
Configuring the branch office zone
1 Configure the branch office zone on the branch office.
In the branch office, only the zone number and bandwidth/codec selection
is configured.
Note: Use the same zone number between the branch office and main
office. The main office configuration (Procedure 15, step 6 on
page 232 )
provides the branch office zone characteristics (local time, local dialing,
and ESA).
2 Configure the routing tables on the SRG.
The SRG must recognize the incoming digits on the Virtual Trunk and
remove all but the ESDN. The call is routed to a local termination.
End of Procedure
- SDRR
ALOW
ARRN
DDD
DENY
DID
ITED
LDDD
LDID
STRK
<cr>
Supplemental Digit Restriction or Recognition
Allowed codes
Alternate Routing Remote Number
Recognized remote Direct Distance Dial codes
Restricted codes
Recognized remote Direct Inward Dial codes
Incoming Trunk group Exclusion Digits
Recognized Local Direct Distance Dial codes
Recognized Local Direct Inward Dial codes
For ADM/MDM trunk groups
Return to SPN
- - DMI 1-255
1-999 Digit Manipulation Index
Digit Manipulation Index with FNP
DMI is only prompted when the Directory Number
Expansion (DNXP) package 150 is equipped and
SDRR = LDID.
LD 90 – Configure ESN Special Number and Digit Manipulation. (Part 2 of 2)
Prompt Response Description