Nortel Networks NN10042-116 - Manual (Page 121)

Charging the battery pack 121
3 Push the top of the battery pack until it snaps into place.
Do not force the battery pack into the handset.
--End--
Changing a battery pack during a call
Follow this procedure to change the battery pack while on a call. For the
location of the release button, refer to IP Phone 2211 handset.
Prerequisites
You must have a replacement battery pack. Replacement battery packs
are available from your supplier or servicing agent.
Procedure Steps
Step Action
Procedure steps
Procedure Steps
Step Action
1 Place the call on hold. See "Place a call on hold" (page 73) .
2 Press the battery release button.
The battery pack releases from the handset.
3 Lift the battery pack out of the handset cavity.
4 Slide the recharged battery pack into the handset cavity.
5 Resume the call. See "Retrieve a call on hold" (page 74) .
--End--
Charging the battery pack
Follow this procedure to charge the battery pack. The handset can be
charged when in a power off or standby state. You must charge the
battery pack before its first use.
The Nortel Networks WLAN Handset Desktop Charger is used to charge
the battery pack. The indicator light on the Desktop Charger lights only
when the handset is inserted correctly into the connector. If the light does
not turn on, check that the handset is correctly inserted and that the
charger is connected to a power source.
Carrier VoIP
Nortel IP Phone WLAN Handset User Guide (CICM)
NN10042-116 04.01 Standard
4 July 2008
Copyright © 2008 Nortel Networks
.