Nortel Networks NN10042-116 - Manual (Page 122)

122 Using the Battery Pack
Prerequisites
You must have the Nortel Networks WLAN Handset Desktop Charger
appropriate for the model of handset.
Attention:
Desktop Charger — To charge the battery pack, always use the Desktop
Charger provided with the handset. Other chargers can damage the
battery pack.
Power Adapter — Use only the original plug-in power adapter provided
with the handset unit.
Procedure Steps
Step Action
1 Press the Power Off/End Call key to terminate any calls. Hold
the key down for two seconds if you want to transition to the
power off state.
The handset can be off or in standby mode when charging.
2 Place the handset face-forward into the Desktop Charger.
The red indicator light turns on.
3 Charge the battery pack.
If the handset is in standby mode, the handset extension number
and
Charging ... appear in the display. The handset is fully
operational and can receive calls.
If the handset is off, the extension number does not appear. The
handset cannot receive calls.
It is normal for the battery pack to warm up when it is recharging.
4 The battery is fully charged when Charge Complete appears in
the display area. The indicator light stays lighted as long as the
handset is connected to the recharger.
Remove the handset from the charger.
--End--
Carrier VoIP
Nortel IP Phone WLAN Handset User Guide (CICM)
NN10042-116 04.01 Standard
4 July 2008
Copyright © 2008 Nortel Networks
.