Nortel Networks NN10042-116 - Manual (Page 47)

47
.
Using the Audio menu
Follow this procedure to view and edit your audio profile.
The audio profiles available to you depend on those selected by the
system administrator. Contact your administrator for recommended
profiles.
You must have permission to edit the audio profile. If the administrator has
granted you permission, a check mark appears beside the active profile in
the display.
The WLAN Handset 2210 Series and WLAN Handset 6100 Series
terminals do not support the Play DTMF message. This message is sent
by the CICM in response to key hit reports, to instruct the terminal to play
in-band DTMF. If these terminals are required to interwork to a voicemail
system or Interactive Voice Response (IVR), the CICM and GWC audio
profiles must be set up to negotiate RFC2833 in order for key hits to be
detected, such as, PIN codes for voicemail accounts.
Prerequisites
• You must be logged on, and the handset must be active.
• The system administrator must grant you permission to edit your audio
profile. A check mark in front of an item indicates that you are in editing
mode.
Procedure Steps
Step Action
1 From the main menu, select Audio, then select and open Audio
Profile.
The Audio Profile screen appears, showing your audio profile. If
you have permission to edit your profile, a check mark appears
beside the active profile.
If you do not have permission to edit your profile, the procedure
is complete.
Carrier VoIP
Nortel IP Phone WLAN Handset User Guide (CICM)
NN10042-116 04.01 Standard
4 July 2008
Copyright © 2008 Nortel Networks
.