Nortel Networks OPTera Metro 3500 - Manual (Page 112)

2-74 Operation, administration, and maintenance (OAM) features
OPTera Metro 3500 Multiservice Platform NTRN10AN Rel 12.1 Standard Iss 1 Apr 2004
• Fully managed through Site Manager (does not support SNMP/ BCC as in
the case of OPE circuit packs)
• Ethernet, WAN and Fibre Channel Operational Measurements (OMs) and
Performance Monitoring (PMs)
• Supports auto-negotiation, flow control and jumbo frame (9600 bytes) on
the Ethernet LAN port(s)
• Supports Small Form-factor Pluggable (SFP) optical interface offering
1000Base-SX(850 nm), 1000Base-LX (1310nm) and 1000Base-ZX
(1550nm) reaches
The 2xGigE/FC-P2P circuit pack complies with the following industry
standards and recommendations:
• ITU-T Draft New Recommendation G.7041, Generic Framing Procedure
(GFP)
• ITU-T Draft Revised Recommendation G.707, Network node interface for
SDH
• ANSI X3.230-1994 Fibre Channel Physical and Signalling Interface
(FC-PH) and for FC-0 (Physical) and FC-1 (Transmission protocol) layers
Note: 2xGigE/FC-P2P circuit pack does not adhere to the Fibre Channel
Arbitrated Loop (FC-AL) standard and therefore does not support Fibre
Channel Arbitrated Loop devices.
Alarm management
The following section describes new alarms specific to the 2xGigE/FC-P2P.
For a detailed description of alarms and clearing procedures, refer to OPTera
Metro 3500 Release 12.0 Alarm and Trouble Clearing NTPs (323-1059-543.1
and 323-1059-543.2).