NETGEAR 7000 Series Managed Switch - Manual (Page 140)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
14-2 Traceroute
v1.0, May 2008
CLI Example
The following shows an example of using the traceroute command to determine how many hops
there are to the destination. The command output shows each IP address the packet passes through
and how long it takes to get there. In this example, the packet takes 16 hops to reach its destination.
(Netgear Switch) #traceroute?
<ipaddr> Enter IP address.
(Netgear Switch) #traceroute 216.109.118.74 ?
<cr> Press Enter to execute the command.
<port> Enter port no.
(Netgear Switch) #traceroute 216.109.118.74
Tracing route over a maximum of 20 hops
1 10.254.24.1 40 ms 9 ms 10 ms
2 10.254.253.1 30 ms 49 ms 21 ms
3 63.237.23.33 29 ms 10 ms 10 ms
4 63.144.4.1 39 ms 63 ms 67 ms
5 63.144.1.141 70 ms 50 ms 50 ms
6 205.171.21.89 39 ms 70 ms 50 ms
7 205.171.8.154 70 ms 50 ms 70 ms
8 205.171.8.222 70 ms 50 ms 80 ms
9 205.171.251.34 60 ms 90 ms 50 ms
10 209.244.219.181 60 ms 70 ms 70 ms
11 209.244.11.9 60 ms 60 ms 50 ms
12 4.68.121.146 50 ms 70 ms 60 ms
13 4.79.228.2 60 ms 60 ms 60 ms
14 216.115.96.185 110 ms 59 ms 70 ms
15 216.109.120.203 70 ms 66 ms 95 ms
16 216.109.118.74 78 ms 121 ms 69 ms