NETGEAR 7000 Series Managed Switch - Manual (Page 84)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
9-8 Access Control Lists (ACLs)
v1.0, May 2008
Web Interface Procedure
To use the Web interface to configure the GSM7248R, proceed as follows:
1. Create VLAN 30 with IP address 192.168.30.1/24:
a. From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar
to the following displays.
b. Enter the following information in the VLAN Routing Wizard:
• In the Vlan ID field, enter 30.
• In the IP Address field, enter 192.168.30.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display.
d. Click the gray box under port 35 twice until U displays. The U specifies that the egress
packet is untagged for the port.
e. Click Apply to save VLAN 30.
Add two static routes so that the switch forwards the packets with destinations
192.168.100.0/24 and 192.168.30.0/24 to the correct next hops.
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#ip route 192.168.100.0 255.255.255.0 192.168.200.1
(Netgear Switch) (Config)#ip route 192.168.30.0 255.255.255.0 192.168.200.1
Figure 9-3