Table 20-1 – NETGEAR 7000 Series Managed Switch User Manual

Page 169

Advertising
background image

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2

Managing Switch Stacks

20-7

v1.0, May 2008

Effects of Replacing a Preconfigured Switch in a Switch Stack

When a preconfigured switch in a switch stack fails, is removed from the stack, and is replaced
with another switch, the stack applies either the preconfiguration or the default configuration to it.
The events that occur when the switch stack compares the configuration with the preconfigured
switch are the same as those described in

“Effects of Adding a Preconfigured Switch to a Switched

Stack”

.

Effects of Removing a Preconfigured Switch from a Switch Stack

If you remove a preconfigured switch from the switch stack, the configuration associated with the
removed stack member remains in the running configuration as configured information. To
completely remove the configuration, use the no member unit_number (this is in the stacking
configuration mode).

Table 20-1. Results of comparing the preconfiguration with the new switch

Scenario

Result

The stack member numbers and the switch types
match.
• If the stack member number of the preconfigured

switch matches the stack member number in the
configuration on the stack, and

• If the switch type of the preconfigured switch

matches the switch type in the configuration on the
stack.

The switch stack applies the configuration to the
preconfigured new switch and adds it to the stack.

The stack member numbers match but the switch
types do not match.
• If the stack member number of the preconfigured

switch matches the stack member number in the
configuration on the stack, but

• The switch type of the preconfigured switch does

not match the switch type in the configuration on
the stack.

• The switch stack applies the default configuration

to the preconfigured switch and adds it to the stack.

• The configuration in the preconfigured switch is

changed to reflect the new information.

The stack member number is not found in the
configuration.

• The switch stack applies the default configuration

to the new switch and adds it to the stack.

• The preconfigured information is changed to reflect

the new information.

The stack member number of the preconfigured
switch is not found in the configuration.

The switch stack applies the default configuration to
the preconfigured switch and adds it to the stack.

Advertising