NETGEAR 7000 Series Managed Switch - Manual (Page 64)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
7-14 IP Routing Services
v1.0, May 2008
Example #2: Enable Routing for Ports
The following command sequence enables routing and assigns IP addresses for ports 1/0/2 and 1/
0/3.
Example #3: Enable RIP for the Switch
The next sequence enables RIP for the switch. the route preference defaults to 15.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit