NETGEAR 7000 Series Managed Switch - Manual (Page 212)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
27-2 Double VLANs
v1.0, May 2008
The example is shown as CLI commands and as a Web interface procedure.
CLI Commands
To use the CLI to enable a double VLAN on a VLAN, enter the following CLI commands:
Figure 27-1
Create a VLAN 200.
(Netgear Switch)#vlan database
(Netgear Switch) (Vlan)#vlan 200
(Netgear Switch) (Vlan)#exit
Add interface 1/0/24 to VLAN 200, add pvid 200 to the port.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#vlan pvid 200
(Netgear Switch) (Interface 1/0/24)#vlan participation include 200
(Netgear Switch) (Interface 1/0/24)#exit
Add interface 1/0/48 to the VLAN 200 in a tagging mode.
(Netgear Switch) (Config)#interface 1/0/48
(Netgear Switch) (Interface 1/0/48)#vlan participation include 200
(Netgear Switch) (Interface 1/0/48)#vlan tagging 200
(Netgear Switch) (Interface 1/0/48)#exit