NETGEAR 7000 Series Managed Switch - Manual (Page 68)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
7-18 IP Routing Services
v1.0, May 2008
Specify Router ID and Enable OSPF for the Switch. The following sequence specifies the
router ID and enables OSPF for the switch. Set disable1583 compatibility to prevent the routing
loop.
Enable and Configure OSPF for the Ports. The following sequence enables OSPF and sets
the OSPF priority and cost for the ports.
(Netgear Switch) #config
(Netgear Switch) (Config)#router ospf
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#router-id 192.150.9.9
(Netgear Switch) (Config router)#no 1583compatibility
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#ip ospf
(Netgear Switch) (Interface 1/0/2)#ip ospf areaid 0.0.0.2
(Netgear Switch) (Interface 1/0/2)#ip ospf priority 128
(Netgear Switch) (Interface 1/0/2)#ip ospf cost 32
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#ip ospf
(Netgear Switch) (Interface 1/0/3)#ip ospf areaid 0.0.0.3
(Netgear Switch) (Interface 1/0/3)#ip ospf priority 255
(Netgear Switch) (Interface 1/0/3)#ip ospf cost 64
(Netgear Switch) (Interface 1/0/3)#exit(Netgear Switch) (Config)#exit