NETGEAR 7000 Series Managed Switch - Manual (Page 115)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Access Control Lists (ACLs) 9-39
v1.0, May 2008
Example #2: permit any
(Netgear Switch) (Config-mac access-list)#permit ?
<srcmac> Enter a MAC address.
any Configure a match condition for all the destination MAC
addresses in the Destination MAC Address field.
(Netgear Switch) (Config-mac access-list)#permit any ?
<dstmac> Enter a MAC address.
any Configure a match condition for all the destination MAC
addresses in the Destination MAC Address field.
(Netgear Switch) (Config-mac access-list)#permit any any ?
assign-queue Configure the Queue Id assignment attribute.
cos Configure a match condition based on a CoS value.
<ethertypekey> Enter one of the following keywords to specify an Ethertype
(appletalk, arp, ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast,
netbios, novell, pppo, rarp).
<0x0600-0xffff) Enter a four-digit hexadecimal number in the range of 0x0600 to
0xffff to specify a custom Ethertype value.
vlan Configure a match condition based on a VLAN ID.
<cr> Press Enter to execute the command.
(Netgear Switch) (Config-mac access-list)#permit any any