NETGEAR 7000 Series Managed Switch - Manual (Page 122)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
10-4 Class of Service (CoS) Queuing
v1.0, May 2008
Example #1: show classofservice trust
Example #2: set classofservice trust mode
(Netgear Switch) #show classofservice trust ?
<cr> Press Enter to execute the command.
(Netgear Switch) #show classofservice trust
Class of Service Trust Mode: Dot1P
(Netgear Switch) (Config)#classofservice ?
dot1p-mapping Configure dot1p priority mapping.
ip-dscp-mapping Maps an IP DSCP value to an internal traffic class.
trust Sets the Class of Service Trust Mode of an Interface.
(Netgear Switch) (Config)#classofservice trust ?
dot1p Sets the Class of Service Trust Mode of an Interface
to 802.1p.
ip-dscp Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
(Netgear Switch) (Config)#classofservice trust dot1p ?
<cr> Press Enter to execute the command.
(Netgear Switch) (Config)#classofservice trust dot1p