NETGEAR 7000 Series Managed Switch - Manual (Page 150)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
17-2 Port Mirroring
v1.0, May 2008
Example #1: show monitor session
Example #2: show port all
Example #3: show port interface
Use this command for a specific port. The output shows whether the port is the mirror or the probe
(Netgear Switch Routing) #show monitor session 1
Session ID Admin Mode Probe Port Mirrored Port
---------- ---------- ---------- -------------
1 Enable 1/0/8 1/0/7
Note: Monitor session ID “1” - “1” is a hardware limitation.
(Netgear Switch Routing) #show port all
Admin Physical Physical Link Link LACP
Intf Type Mode Mode Status Status Trap Mode
---- ---- ------ -------- ------- ------ ---- ----
1/0/1 Enable Auto Down Enable Enable
1/0/2 Enable Auto Down Enable Enable
1/0/3 Enable Auto Down Enable Enable
1/0/4 Enable Auto Down Enable Enable
1/0/5 Enable Auto Down Enable Enable
1/0/6 Enable Auto Down Enable Enable
1/0/7 Mirror Enable Auto Down Enable Enable
1/0/8 Probe Enable Auto Down Enable Enable
1/0/10 Enable Auto Down Enable Enable