NETGEAR 7000 Series Managed Switch - Manual (Page 19)

1-1
v1.0, May 2008
Chapter 1
Introduction
This document provides an understanding of the CLI and Web configuration options for software
Release 7.2 features.
Document Organization
This document provides examples of the use of the switch software in a typical network. It
describes the use and advantages of specific functions provided by the 7000 Series Managed
Switch, and includes information on configuring those functions using the Command Line
Interface and Web Interface.
The switch software can operate as a Layer 2 switch, a Layer 3 router, or a combination switch/
router. The switch also includes support for network management and Quality of Service functions
such as Access Control Lists and Differentiated Services. Which functions you choose to activate
will depend on the size and complexity of your network: this document describes configuration for
some of the most-used functions.
This document contains configuration information about the following:
• Layer 2
– VLANs
• Layer 3
– Port routing
– VLAN Routing
– Virtual Router Redundancy Protocol (VRRP)
– RIP
– OSPF
– Proxy ARP
• Quality of Service (QoS)
– Access Control Lists (ACLs)