NETGEAR 7000 Series Managed Switch - Manual (Page 197)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Protected Ports 25-3
v1.0, May 2008
Web Interface Procedure
To use the Web Interface to configure a protected port in order to isolate ports, proceed as follows:
1. Create a DHCP pool:
Step 2: Create one VLAN 202 connected to the Internet.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 202
(Netgear Switch) (Vlan)#vlan routing 202
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #configure
(Netgear Switch) (Config)#interface 1/0/48
(Netgear Switch) (Interface 1/0/48)#vlan pvid 202
(Netgear Switch) (Interface 1/0/48)#vlan participation include 202
(Netgear Switch) (Interface 1/0/48)#exit
(Netgear Switch) (Config)#interface vlan 202
(Netgear Switch) (Interface-vlan 202)#routing
(Netgear Switch) (Interface-vlan 202)ip address 10.100.5.34 255.255.255.0
(Netgear Switch) (Interface-vlan 202)#exit
Step 3: Create a DHCP pool to allocate IP addresses to PCs.
(Netgear Switch) (config)#service dhcp
(Netgear Switch) (config)#ip dhcp pool pool-a
(Netgear Switch) (Config-dhcp-pool)#dns-server 12.7.210.170
(Netgear Switch) (Config-dhcp-pool)#default-router 192.168.1.254
(Netgear Switch) (Config-dhcp-pool)#network 192.168.1.0 255.255.255.0
(Netgear Switch) (Config-dhcp-pool)#exit
Step 4: Enable IProuting and Configure a default route.
(Netgear Switch)(config)#ip routing
(Netgear Switch)(config)#ip route 0.0.0.0 0.0.0.0 10.100.5.252
Step 5: Enable a protected port on 1/0/23 and 1/0/24.
(Netgear Switch) (Config)#interface 1/0/23
(Netgear Switch) (Interface 1/0/23)#switchport protected
(Netgear Switch) (Interface 1/0/23)#exit
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#switchport protected
(Netgear Switch) (Interface 1/0/24)#exit
Note: This example assumes that the DHCP service is enabled. For information about
how to enable the DHCP service, see the Web interface procedure in
“Example 1#: Configure DHCP Server in Dynamic Mode” in Chapter 24