NETGEAR 7000 Series Managed Switch - Manual (Page 35)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Using Ezconfig for Switch Setup 3-3
v1.0, May 2008
If an IP address is already assigned, and you do not wish to change the IP address again, simply
type N.
Assigning Switch Name and Location Information
Ezconfig will proceed to the next step in the setup:
Saving the Configuration
After the name and location values are entered, Ezconfig will ask if you would like to have the
changes be saved into the Flash (permanently storage). Enter Y to save the configuration.
Do you want to assign switch name and location information (Y/N/Q)?
System Name: Alpha1-1
System Location: Bld1
System Contact: James
There are changes detected, do you wish to save the changes permanently (Y/N)?
Note: The System Name, System Location and System Contact fields accept only
alphanumeric characters, characters like "#$…" are not supported.
Note: The maximum length of the value cannot be longer than 31 bytes.
There are changes detected, do you wish to save the changes permanently (Y/N)?
y
The configuration changes have been saved successfully.
Please enter 'show running-config' to see the final configuration.
Thanks for using EzConfig!