NETGEAR 7000 Series Managed Switch - Manual (Page 56)

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
7-6 IP Routing Services
v1.0, May 2008
Example #1: Create Two VLANs
The following code sequence shows an example of creating two VLANs with egress frame tagging
enabled.
Example #2: Set Up VLAN Routing for the VLANs and the Switch.
The following code sequence shows how to enable routing for the VLANs:
This returns the logical interface IDs that will be used instead of slot/port in subsequent routing
commands. Assume that VLAN 10 is assigned ID 3/1 and VLAN 20 is assigned ID 3/2.
Enable routing for the switch:
(Netgear Switch) #vlan data
(Netgear Switch) (Vlan)#vlan 10
(Netgear Switch) (Vlan)#vlan 20
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #conf
(Netgear Switch) (Config)#interface range 1/0/1-1/0/2
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan participation include 10
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan pvid 10
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#vlan participation include 20
(Netgear Switch) (Interface 1/0/3)#vlan pvid 20
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#vlan port tagging all 10
(Netgear Switch) (Config)#vlan port tagging all 20
(Netgear Switch) (Config)#exit
(Netgear Switch) #vlan data
(Netgear Switch) (Vlan)#vlan routing 10
(Netgear Switch) (Vlan)#vlan routing 20
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit