National Instruments Network Device DAQ S - Manual (Page 169)

Index
© National Instruments Corporation I-5 NI 6124/6154 User Manual
finite pulse train timing generation, 7-22
FREQ OUT signal, 7-30
frequency
division, 7-24
generation, 7-23
generator, 7-23
measurement, 7-9
Frequency Output signal, 7-30
G
generations
clock, 9-1
continuous pulse train, 7-21
digital waveform, 6-5
frequency, 7-23
pulse for ETS, 7-24
pulse train, 7-21
retriggerable single pulse, 7-20
simple pulse, 7-19
single pulse, 7-19
single pulse with start trigger, 7-20
getting started, 1-1
DIO applications in software, 6-10
glitches, 5-2
H
hardware, 1-2
help, technical support, B-1
hysteresis, analog edge triggering with, 11-4
I
I/O connector
NI 6124, A-2
NI 6154, A-8
signal descriptions
isolated devices, 3-2
non-isolated devices, 3-1
I/O protection, 6-7, 8-8
input coupling, 4-2
input polarity and range, 4-3
input signals
using PFI terminals as, 8-4
using RTSI terminals as, 9-6
installation
hardware, 1-2
NI-DAQmx, 1-1
other software, 1-1
instrument drivers (NI resources), B-1
instrumentation amplifier, 4-2
interrupt request (IRQ), 10-2
IRQ, 10-2
isolation (NI 6154), A-11
digital isolation, A-12
K
KnowledgeBase, B-1
L
LabVIEW documentation, xii
LabWindows/CVI documentation, xiii
M
Measurement Studio documentation, xiii
measurements
buffered period, 7-7
buffered pulse-width, 7-5
buffered semi-period, 7-8
buffered two-signal edge-separation, 7-18
choosing frequency, 7-12
frequency, 7-9
period, 7-6
position, 7-14
pulse-width, 7-4
semi-period, 7-7
single period, 7-6