National Instruments Network Device DAQ S - Manual (Page 172)

Index
NI 6124/6154 User Manual I-8 ni.com
signals
AI Convert Clock, 4-16
AI Convert Clock Timebase, 4-17
AI Reference Trigger, 4-19
AI Sample Clock, 4-14
AI Sample Clock Timebase, 4-16
AI Start Trigger, 4-18
Change Detection Event, 6-8
connecting digital I/O, 6-9
connecting PFI input, 8-6
Counter n A, 7-28
Counter n Aux, 7-28
Counter n B, 7-28
Counter n Gate, 7-27
Counter n HW Arm, 7-29
Counter n Internal Output, 7-29
Counter n Source, 7-26
Counter n TC, 7-29
Counter n Up_Down, 7-29
Counter n Z, 7-28
counters, 7-25
DI Sample Clock, 6-4
DO Sample Clock, 6-5
exporting timing output using PFI
terminals, 8-4
FREQ OUT, 7-30
Frequency Output, 7-30
simple pulse generation, 7-19
single
period measurement, 7-6
point edge counting, 7-2
pulse generation, 7-19
retriggerable, 7-20
with start trigger, 7-20
pulse-width measurement, 7-4
semi-period measurement, 7-8
two-signal edge-separation
measurement, 7-18
software, 1-1
AI applications, 4-21
AO applications, 5-11
DIO applications for isolated
devices, 6-13
NI resources, B-1
programming devices, 2-6
routing signals in, 9-10
specifications
device, 1-3
NI 6124, A-6
NI 6154, A-13
start trigger, 7-31
static DIO, 6-2
S Series isolated devices (NI 6154), 6-11
using PFI terminals as, 8-5
support, technical, B-1
synchronization modes, 7-37
80 MHz source, 7-38
external source, 7-39
other internal source, 7-39
synchronizing multiple devices, 9-3
synchronous counting mode, 7-34
system timing controller
DAQ-STC2 (isolated devices), 2-3
T
technical support, xv, B-1
terminals
connecting counter, 7-30
NI-DAQmx default counter, 7-30
Timebase
100 kHz, 9-2
20 MHz, 9-2
80 MHz, 9-2
timing output signals, exporting using PFI
terminals, 8-4
timing signals
waveform generation, 5-6
training, xv