White Bear Technologies RoamEO GPS Pet Location System - Manual (Page 6)

4
Introduction to your RoamEO GPS Pet Location System
The RoamEO GPS Pet Location System is made up of two compo-
nents: a handheld GPS Receiver and a special GPS-enabled collar for
your pet. Both components are required for a functional system.
RoamEO GPS Receiver
The RoamEO GPS Receiver is designed to display the location and
movements of your pet within a one mile radius. It does not require any
set up to operate, nor does it need a third party service to function.
1
3
6
7 8 9 10 11
5
4
2
RoamEO GPS Receiver
RF Antenna: RoamEO will operate
effectively with the antenna in the down
position. However, if moved into an
upright position, the range of the radio
may be improved.
Zoom Button: Use this button
to change the scale
of the
tracking screen.
By pressing the + side, the
screen will zoom in. By
pressing the – side, the
screen will zoom out.
Power Switch: This button
powers the GPS
Receiver on and off.
LCD
LED Indicator Lights: Indicate
charge status when the system
is plugged into
the Power Adapter.
The Red LED will be illuminated
when the Power Adapter is
plugged in and the system is
charging. The Green LED will be
illuminated when the system is fully
charged. The LEDs are only used
during the charging cycle and will
not be on
at any other time.
Charging Port:
Insert Power
Adapter plug here
to charge the
GPS Receiver.
Option Button: This button is used
in combination with other buttons
to allow you to perform an
operation or move between the
different tracking screens.
Screen Button:
Used to change
between the
different screen
views that are
available for use.
Alarm
Button:
Turns the
audible
alarm
on or off.
Enrollment:
Used for
enrolling
Collars with
the GPS
Receiver.
Fence Button: Used to
program a GPS Fence.
When a GPS Fence
has been stored in
memory, this button
allows you to turn the
GPS Fence on or off.