ZyXEL Communications GS-4024 - Manual (Page 329)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
329
The following table describes command interpreter modes and how to access them.
Enter exit to quit from the current mode or enter logout to exit the command interpreter.
45.9 Getting Help
The system includes a help facility to provide you with the following information about the
commands:
• List of available commands under a command group.
• Detailed descriptions of the commands.
Table 136 Command Interpreter Mode Summary
MODE . DESCRIPTION
HOW TO LOGIN/
ACCESS
PROMPT
User Commands available in this mode are
a subset of enable mode. You can
perform basic tests and display
general system information. Default login level for a
read-only account. sysname>
The first part of the prompt is
the system name. In the CLI
examples in this User’s
Guide, the system name is
always “sysname”.
Enable Commands available in this mode
allow you to save configuration
settings, reset configuration settings
as well as display further system
information. This mode also contains
the
configure command which
takes you to config mode.
Default login level for
accounts with a
privilege of 13 or 14.
Read-only accounts
(with a privilege of 0-
12) need to type the
enable command
and enter enable mode
password.
sysname#
Config Commands available in this mode
allow you to configure settings that
affect the Switch globally. Type config in
enable mode.
sysname(config)#
Command modes that follow are sub-modes of the config mode and can only be accessed from within the config
mode.
Config-vlan This is a sub-mode of the config mode
and allows you to configure VLAN
settings. Type vlan followed
by a number (between
1 to 4094). For
example,
vlan 10 to
configure settings for
VLAN 10.
sysname(config-vlan)#
Config-interface This is a sub-mode of the config mode
and allows you to configure port
related settings. Type interface
port-channel
followed by a port
number. For example,
i
nterface port-
channel 8 to
configure port 8 on the
Switch.
sysname(config-
interface)#
Config-mvr This is a sub-mode of the config mode
and allows you to configure multicast
VLAN settings. To enter MVR mode,
enter mvr followed by
a VLAN ID (between 1
and 4094). For
example, enter
mvr 2
to configure multicast
settings on VLAN 2.
sysname(config-mvr)#