ZyXEL Communications GS-4024 - Manual (Page 335)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
335
<0-14> Accesses Enable mode
commands up to the privilege
level specified. 0
erase running-config Resets to the factory default
settings. 13
help Displays help information for this
command. 13
interface port-
channel <port-
list> [bandwidth-
limit...]
Resets to the factory default
settings on a per port basis and
optionally on a per feature
configuration basis. 13
ethernet
oam
remote-loopback
test <port>
[<number of
packets> [<packet
size>]]
Performs a loopback test from the
specified port, optionally specifies
how many and the size of packets
sent in the loopback test. 13
exit Exits Enable (or privileged) mode. 0
help Displays help information. 0
history Displays a list of command(s) that
you have previously executed. 0
igmp-flush Removes all IGMP information. 13
kick tcp <Session ID> Disconnects the specified TCP
session. 13
logout Exits Enable (or privileged) mode. 0
mac-flush Clears the MAC address table. 13
<port-num> Removes all learned MAC
address on the specified port(s). 13
no arp Flushes the ARP table entries. 13
arp inspection filter
<mac-addr> vlan
<vlan-id>
Specify the ARP inspection record
you want to delete from the
Switch. The ARP inspection
record is identified by the MAC
address and VLAN ID pair. 13
interface <port-number> Clears all counters on the
specified port. 13
logging Disables syslog logging. 13
ping
<IP|host-
name>
Sends Ping request to an Ethernet
device. 0
[vlan <vlan-
id>][..]
Sends Ping request to an Ethernet
device in the specified VLAN(s). 13
reload config <index> Restarts the system and use the
specified configuration file. 13
renew dhcp
snooping
database
Loads dynamic bindings from the
default DHCP snooping database. 13
Table 138 Command Summary: Enable Mode (continued)
COMMAND DESCRIPTION PRIVILEGE