ZyXEL Communications GS-4024 - Manual (Page 368)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
368
45.12.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
<SPTPID> Sets the SP TPID (Service
Provider Tag Protocol Identifier). 13
vlan-type <802.1q|port-
based>
Specifies the VLAN type. 13
Table 139 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 140 interface port-channel Commands
COMMAND DESCRIPTION PRIVILEGE
interface
port-
channel
<port-
list>
Enables a port or a list of ports for
configuration. 13
arp inspection trust Sets the port to be a trusted port
for arp inspection. The Switch
does not discard ARP packets on
trusted ports for any reason. 13
limit rate <pps> Specifies the maximum rate (1-
2048 packets per second) at
which the Switch receives ARP
packets from each port. The
Switch discards any additional
ARP packets. Enter 0 to disable
this limit. 13
limit rate <pps>
burst interval
<seconds>
Specifies the length (1-15
seconds) of the burst interval.
The burst interval is the length of
time over which the rate of ARP
packets is monitored for each
port. 13
bandwidth-limit Enables ingress (pir), cir and
egress limits on the port(s). 13
cir Enables the guaranteed
bandwidth limits for incoming
traffic on the port(s). 13
cir <Kbps> Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s). 13
pir Enables bandwidth limits allowed
for incoming traffic on the port(s). 13
pir <Kbps> Sets the maximum bandwidth
allowed for incoming traffic on the
port(s). 13
egress Enables bandwidth limits allowed
for outgoing traffic on the port(s). 13