ZyXEL Communications GS-4024 User Manual
Page 363
Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
363
no network <ip-
addr/bits>
Deletes the OSPF network.
13
no redistribute
rip
Sets the Switch not to learn RIP
routing information.
13
no redistribute
static
Sets the Switch not to learn static
routing information.
13
redistribute
rip metric-type
<1|2> metric <0-
65535>
Sets the Switch to learn RIP
routing information which will use
the specified metric information.
13
redistribute
static metric-
type <1|2>
metric <0-
65535>
Sets the Switch to learn static
routing information which will use
the specified metric information.
13
passive-iface
<ip-addr/bits>
Sets the interface to be passive.
A passive interface does not
send or receive OSPF traffic.
13
rip
Enables and enters the RIP
configuration mode.
13
exit
Leaves the RIP configuration
mode.
13
vrrp network <ip-
address>/<mask-
bits> vr-id <1-7>
uplink-gateway
<ip>
Adds a new VRRP network nd
enters the VRRP configuration
mode.
13
exit
Exits from the VRRP command
mode.
13
inactive
Disables the VRRP settings.
13
interval
<1..255>
Sets the time interval (in
seconds) between Hello
message transmissions.
13
name <name
string>
Sets a descriptive name of the
VRRP setting for identification
purposes.
13
no
inactive
Activates this VRRP.
13
no
preempt
Disables VRRP preemption
mode.
13
no primary-
virtual-ip
Resets the network to use the
default primary virtual gateway
(interface IP address).
13
no secondary-
virtual-ip
Sets the network to use the
default secondary virtual
gateway (0.0.0.0).
13
preempt
Enables preemption mode.
13
primary-
virtual-ip <ip>
Sets the primary VRRP virtual
gateway IP address.
13
Table 139 Command Summary: Configuration Mode (continued)
COMMAND
DESCRIPTION
PRIVILEGE