ZyXEL Communications GS-4024 User Manual
Page 361
Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
361
igmp
Enables and enters the IGMP
configuration mode.
13
exit
Leaves the IGMP configuration
mode.
13
non-querier
Sets the Switch to Non-Querier
mode. (If a multicast router with a
lower IP address, it will stop
sending Query messages on that
network.)
13
no non-querier
Disables non-querier mode on
the Switch, (a multicast router
always sends Query messages).
13
unknown-
multicast-frame
<drop|flooding>
Specifies the action the Switch
should perform when it receives
unknown multicast frames.
13
ospf <router-id>
Enables and enters the OSPF
configuration mode.
13
area <area-id>
Enables and sets the area ID.
13
area <area-id>
authentication
Enables simple authentication for
the area.
13
area <area-id>
authentication
message-digest
Enables MD5 authentication for
the area.
13
area <area-id>
default-cost
<0-16777214>
Sets the cost to the area.
13
area <area-id>
name <name>
Sets a descriptive name for the
area for identification purposes.
13
area <area-id>
stub
Enables and sets the area as a
stub area.
13
area <area-id>
stub no-summary
Sets the stub area not to send
any LSA (Link State
Advertisement).
13
area <area-id>
virtual-link
<router-id>
Sets the virtual link ID
information for the area.
13
area <area-id>
virtual-link
<router-id>
authentication-
key <key>
Enables simple authentication
and sets the authentication key
for the specified virtual link in the
area.
13
area <area-id>
virtual-link
<router-id>
authentication-
same-as-area
Sets the virtual link to use the
same authentication method as
the area.
13
Table 139 Command Summary: Configuration Mode (continued)
COMMAND
DESCRIPTION
PRIVILEGE