ZyXEL Communications GS-4024 User Manual
Page 372
Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
372
ingress-check
Disables ingress checking on the
port(s).
13
intrusion-lock
Disables intrusion-lock on a port
so that a port can be connected
again after you disconnected the
cable.
13
ipmc egress-
untag-vlan <vlan-
id>
Disables the port(s) from
removing specified VLAN tag from
IP multicasting packets before
forwarding.
13
loopguard
Disables the loop guard feature
on the port(s).
13
mac-
authentication
Disables MAC authentication via
a RADIUS server on the port(s).
13
mirror
Disables port mirroring on the
port(s).
13
multicast-limit
Disables multicast limit on the
port(s).
13
trtcm
Disables 2-rate 3-color marking
on the port(s).
13
vlan-trunking
Disables VLAN trunking on the
port(s).
13
pvid <vlan-id>
The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1
to 4094 for the specified interface.
13
qos
priority <0 .. 7>
Sets the quality of service priority
for an interface.
13
speed-duplex <auto|10-half|10-
full|100-
half|100-
full|1000-full>
Sets the duplex mode (
half
or
full
) and speed (
10
,
100
or
1000
Mbps) of the connection on
the interface. Selecting
auto
(auto-negotiation) makes one port
able to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
13
spq
Sets the port(s) to use Strict
Priority Queuing.
13
trtcm
Enables Two Rate Three Color
Marker on the port(s).
13
cir <Kbps>
Sets the Commit Information Rate
on the port(s).
13
pir <Kbps>
Sets the Peak Information Rate
on the port(s).
13
dscp green <0-63>
DSCP value to use for packets
with low packet loss priority.
13
dscp yellow <0-
63>
DSCP value to use for packets
with medium packet loss priority.
13
dscp red <0-63>
DSCP value to use for packets
with high packet loss priority.
13
Table 140 interface port-channel Commands (continued)
COMMAND
DESCRIPTION
PRIVILEGE