ZyXEL Communications GS-4024 - Manual (Page 339)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
339
dvmrp neighbor Displays DVMRP neighbor
information. 3
dvmrp prune Displays the DVMRP prune
information. 3
dvmrp route Displays the DVMRP routes. 3
igmp group Displays multicast group details
for each port(s). 3
igmp interface Displays IGMP settings for each
IP interface. 3
igmp multicast Displays details about known and
unknown multicast frames
passing through the Switch on the
specified port(s). 3
igmp timer Displays IGMP counter and timer
settings for each IP interface. 3
iptable all
[IP|VID|PORT]
Displays the IP address table. You
can sort the table based on the IP
address, VLAN ID or the port
number. 3
iptable count Displays the number of IP
interfaces configured on the
Switch. 3
iptable static Displays the static IP address
table. 3
ospf database Displays OSPF link state
database information. 3
ospf interface Displays OSPF interface settings. 3
ospf neighbor Displays OSPF neighbor
information. 3
protocol-based-
vlan
Displays protocol based VLAN
settings on the port(s). 3
route Displays IP routing information. 3
route static Displays IP static route
information. 3
source binding Displays the static bindings (IP to
MAC address) configured on the
Switch. 3
source binding
[<mac-addr>]
[...]
Displays the static bindings
configured on the Switch based
on MAC address or VLAN ID of
the static binding. 3
source binding
help
Displays help information for the
source binding command.
3
tcp Displays IP TCP information. 3
udp Displays IP UDP information. 3
lacp Displays LACP (Link Aggregation
Control Protocol) settings. 3
logging Displays system logs. 3
Table 138 Command Summary: Enable Mode (continued)
COMMAND DESCRIPTION PRIVILEGE