Yamaha SRCP - Manual (Page 163)

10-
17
10
OTHER OPERA
TIONS
10-6 Using a Memory Card
7) When the load area was selected in step 5, the
data load screen appears. Select the data to be
loaded.
To load the program data, press F1 (PGM).
To load the point data, press F2 (PNT).
To load the parameter data, press F3 (PRM).
To load all of the program, point and param-
eter data, press
F4 (ALL).
[B.UP-LOAD]AREA 3
Select menu
1PGM 2PNT 3PRM 4ALL
[B.UP-LOAD]AREA 3
program data
overwrite OK ?
1yes 2no
[B.UP-LOAD]AREA 3
program data
load OK ?
1yes 2no
[B.UP-LOAD]AREA 3
loading ...
[B.UP-LOAD]AREA 3
Select menu
1PGM 2PNT 3PRM 4ALL
8) When F1 (PGM) or F2 (PNT) was selected
in step 7, a confirmation message appears ask-
ing whether to overwrite the data.
Pressing F1 (yes) overwrites the data only
with the same program numbers or point num-
bers. (The previous data remains if its program
or point number differs from the program or
point number to be loaded.)
Pressing F2 (no) loads the data after initial-
izing the data in the SRCP controller.
When F4 (ALL) was selected in step 7, all
data in the SRCP controller will be initialized
and then loaded.
9) A confirmation message appears asking
whether to load the data.
To load the data, press F1 (yes)
To cancel, press F2 (no).
10)This screen is displayed while data is being
loaded.
11)When data loading is complete, the screen re-
turns to step 7.
c
CAUTION
Never eject the memory card during loading of data.
Do not leave the memory card inserted into the TPB when not in use. This shortens the backup battery life.