Pa rameters – Yamaha SRCP User Manual

Page 68

Advertising
background image

5-

10

5

PA

RAMETERS

5-2 Parameter Description

PRM34: System mode selection

This parameter specifies the system operation mode. When you want to use the SRCP
series in operating specifications that differ from normal mode, change this parameter as
explained below.
This parameter functions are allocated in bit units.

Input range:

0 to 255

Default value: 0

Function allocation in bit units

Example: To turn off the END output sequence after the controller has started normally, and disable the

interlock function:

PRM34 should be set to "68" because of 0000000001000100 (binary)=68 (decimal)

Function

Bit

Bit

Setting

Addition value

15 to 8

0

0

6

1

64

7

0

0

5 to 4

0

0

3

0

0

2

1

4

1

0

0

0

0

0

PRM34

64+4=68

0

1

2

3

4 to 5

6

7

8 to 15

Reserved for system use

READY signal sequence setting

END signal sequence setting when the
controller has started normally

Voltage check setting for system backup
battery

Reserved for system use

Interlock function setting

END output sequence setting at command
execution completion

Reserved for system use

Selected operating mode

ON when emergency stop is canceled. (DRCA compatible)

ON when servo is ON. (SRCA compatible)

ON after controller has started normally.

OFF after controller has started normally.

Check

No check

Enable

Disable

ON at normal command completion

ON at command signal OFF at normal command completion

Setting

Addition value

0

0

1

0

1

0

1

0

0

1

0

1

0

0

0

2

0

4

0

8

0

0

64

0

128

0

Bit 1: READY signal sequence setting

This selects whether to set the READY signal sequence compatible with the DRCA
or SRCA controller.
In DRCA compatible mode, the READY signal turns on at the instant that emer-
gency stop is released. In the SRCA compatible mode the READY signal turns on
when the servo is turned on. (The READY signal will not turn on just by releasing
emergency stop.)

Bit 2: END signal sequence setting when the controller has started nor-

mally

This selects whether to turn on the END signal when the controller has started
normally.
In normal mode, the END signal turns on when the controller has started normally.
In conventional compatible mode, the END signal remains off even when the con-
troller has started normally.

Bit 3: Voltage check setting for system backup battery

This selects whether to check the system backup battery voltage when the control-
ler servo is turned on.
In such cases where you want to operate the robot immediately even when the
battery needs to be replaced, you can temporarily disable this voltage check.
(System backup batteries are located inside the controller and used to back up the
parameters and point data.)

Bit 6: Interlock function setting

This selects whether to enable or disable the interlock function. The interlock func-
tion is enabled by default. If the interlock function is disabled, use caution and be
aware of the robot movement.

Advertising