Xantrex Technology XDI2048 - Manual (Page 30)

Rack Mount Frame Assembly and Installation
2-10 TM-DIOP-01XN-01
Load Connection
1. If necessary, remove the output cover by loosening the two securing
nuts. Release the clamp on the strain relief and insert one end of the
load wire
2. Strip and install appropriately sized spade or ring terminals on the two
load lines. Only use a ring type terminal for the safety ground
connection.
3. Loosen or remove the two screws on the barrier strip and insert the
load connections noting polarity if neutral is chosen. Tighten screws
to secure.
4. Connect the safety ground wire to the ground stud provided. The
ground stud accepts a 0.2 in. (5 mm) #10 diameter ring terminal.
5. Route the load wires inside the cover to prevent pinching but with a
sufficient service loop. Replace cover and secure. Tighten clamping
screw on strain relief to secure wire in place.
WARNING
Exercise caution when making connections to a rack in an existing installation.
Ensure all input and output breakers are de-energized and that adjacent racks are
also powered down.
LINE 2
LINE 1
GROUND
1.97"
[50 mm]
[70 mm]
2.76"