Xantrex Technology XDI2048 - Manual (Page 44)

Inverter Module Installation and Operation
3-2 TM-DIOP-01XN-01
Installation into Rack Mount Frame
Installing To install an inverter module, slide it into a pre-wired rack mount frame
until the mounting ears are flush with the front of the rack. In order to
prevent the inverter from being accidentally displaced from its proper
position, apply the captive screws.
The mating of the inverter with the rack mount frame should be
established without excessive force. If the unit does not slide into the rack
mount frame completely, please verify that the rack mount frame was
assembled and installed into the equipment rack according to “Installation
Into Cabinet Style Equipment Racks” on page 2–5 or “Installation into
Relay Racks” on page 2–6.
The inverter is a forced air cooled device. Please observe that the air
intake and exhaust are not blocked (refer to “Initial Inspection” on
page 2–2).
Please refer to Figure 3-1.
WARNING
During the installation or removal of the inverter, ensure that the power switch
(see Figure 3-2) is in the off position.