Xantrex Technology XDI2048 - Manual (Page 57)

Initial Setup
TM-DIOP-01XN-01 4-3
Figure 4-1 Ethernet Interface PCB
Important: The only way to configure the interface card is through the
Ethernet port using TCP/IP protocol. Therefore, the Ethernet interface must be
set up properly the first time. Once it is setup, the parameters (such as, password
and IP address) should be saved in a safe place. Table 4-2 is provided to record
your settings after they have changed.
3.45 " [88 mm]
[96 mm]
Ethernet Board Top View Ethernet Board Bottom View