Xantrex Technology XDI2048 - Manual (Page 66)

Remote Communication & Monitoring
4-12 TM-DIOP-01XN-01
Password
The Web page interface is password protected. See “Password” on
page 4–12 for the default password. The Web page uses the industry
standard MD5 algorithm to authenticate the remote user.
Network configurations (Default IP, SMTP Server etc.) are protected with
one password (at+iRPG) and all other settings (for example, Monitor
Refresh Rate and Standby) are protected by another (at+iWPWD). For
simplicity, the Web interface will set both passwords to the same value.
Therefore, when you try to change a parameter, a password prompt may
appear twice. After submitting a password you can freely change
parameters for 10 minutes.
Figure 4-6, “Password Confirmation Boxes” on page 4–12 shows the
screen that will appear when both passwords are needed. There may be
only one box at other times. Enter the previously saved password into
both boxes and select “Submit”.
Passwords must be 4 to 10 characters long. To disable the password enter
a new password with blanks in the Setup Page (see page 4–15).
Important: If you forget the password, you can reset all the parameters by
following the procedure described in “Resetting” on page 4–6.
Figure 4-6 Password Confirmation Boxes