Vitek VT-4060 SR - Manual (Page 12)

ENGLISH
12
Troubleshooting
Before resorting to maintenance service, please kindly check by yourself with the following chart.
Trouble shooting
Symptom Cause Solution
No power The power cord isn’t connected Connect the cord to player
Fuse melting Replace the cord with the same one
TV receiver setup is not correct Change TV receiver setup
No picture Video setup is not correct Change video setup
Video cable isn’t connected well Connect the cable properly
Distorted picture Dirty disc Clean the disc
In fast forward or fast rewind mode Sometimes, tiny distortion appears normally
Luminance unsteady
or picture with noise Anti copy circuit influence Connect the DVD unit to TV directly
Unable to play Without disc Load the disc
Disc is damaged Clean or replace the disc
Disc is put upside down Load the disc properly
Dirty disc Clean the disc
There are menu on TV screen Use SETUP to turn off menu
Parental control is working Set up parental off or change the setup
Key malfunction Power wave or other static interference Turn on/off the power and try again.
Remote control doesn’t work Remote control is not directed properly Point the remote control at the sensor
Remote control is too far from DVD unit Come inside the remote control operation space
Batteries are weak Replace the batteries
No radio signal Antenna is not connected Connect antenna
Signal source is chosen improperly Switch source signal to tuner mode
Specification
DVD receiver
Power supply AC ~230V/50Hz
Power consumption 175W
Working environment Temperature 10°С - +40°С
Relative humidity 5% 90%
Disc output TV System PAL, NTSC
Frequency response 20 Hz - 20kHz
S/N(A weight) > 80 dB (1 kHz)
THD+NOISE < 60 dB (1 kHz)
WOW FLUTTER Below the limit of apparatus measure
Tuner AM frequency Range 522 kHz – 1620 kHz
FM frequency Range 64 MHz – 108 MHz
Power output (Max) 25 W*5 + 50 W
Frequency response instability ±1.5 dB
The manufacturer reserves the right to make changes to the characteristics of the device without prior notice.
The service life of the device is no less than five years.
Guarantee
Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
This product conforms to the EMC-Requirements as laid down by the Council Directive
89/336/EEC and to the Low Voltage Regulation (23/73 EEC)
A production date of the item is indicated in the serial number on the technical data plate. A serial number is an eleven-unit number, with the first four
figures indicating the production date. For example, serial number 0606ххххххх means that the item was manufactured in June (the sixth month)
2006.
4060.indd 12 4060.indd 12 23.10.2006 9:25:14 23.10.2006 9:25:14