Vitek VT-4060 SR - Manual (Page 8)

ENGLISH
8
DIGITAL AUDIO SETUP PAGE
DIGITAL OUTPUT:
SPDIF OFF:
No digital output (coaxial off), only analog audio output.
ALL:
If this item is selected, you can set up RAW.
PCM ONLY:
In SPDIF/PCM mode, setup PCM channel according to your preference.
LPCM OUT:
Select PCM frequency at 48kHz or 96kHz.
Note: Some amplifiers don’t support 96kHz sampling, which will affect
the coaxial output.
DOLBY DIGITAL SETUP
DUAL MONO:
Stereo: Set audio output to the stereo output.
L mono: Set audio output to the mono left channel.
R mono: Set audio output to the mono right channel.
Mix mono: Set audio output to the mix mono channel.
DYNAMIC:
Select this to reduce the overall volume and still keep defined audio
sound.
CHANNEL DELAY PAGE:
If the above setup is dissatisfying, you can set the speaker distances in
the real conditions. Press up/down direction key to select the speaker,
and press left/right direction key to adjust the distance.
EQUALIZER:
In this item you can set sound mode, bass boost, super bass and treble
boost. You can select one according to your preference and the disc
content.
You can press up and down direction key to adjust it.
3D PROCESSING:
In PROLOGIC ON mode, the reverb mode setup is available.
HDCD SETUP:
You can select the digital filter at off 1x and 2x.
KARAOKE
KARAOKE can be controlled to output by the setup menu. There are 2
optional output modes: ON/OFF.
Adjust microphone volume to the minimum level. Insert
microphone into the microphone jack.
Use the microphone volume knob to adjust the microphone
volume. Press up/down direction key to adjust the echo
level in the setup menu.
When playing karaoke disc, to eliminate the original singing, press [L/R/
ST] key on the remote controller to select left channel or right channel.
When playing DVD disc, press [AUDIO] to eliminate its original singing.
VIDEO SETUP PAGE
COMPONENT V IDEO:
OFF:
Set video output to the composite.
YUV:
Set video output in analog component video format when connecting to
Y/U/V terminals.
P YUV:
Set progressive YUV signals. Connection same as YUV.
RGB:
Set video output in Red/Green/Blue format when connecting to SCART
terminal.
P RGB:
Progressive RGB signals. Connection same as RGB.
VGA:
Set to this item when connecting to VGA terminal.
Note: If the video setting differs with the physical connection, the TV set
may not have picture. In this case, you can RESET the machine, then
keep pressing key [V_MODE] until the picture returns again.
COLOR SETTING SETUP:
COLOR SETTING includes: SHARPNESS, BRIGHTNESS, CONTRAST,
GAMMA, HUE, SATURATION and LUMA DELAY.
SHARPNESS: There are three optional output modes: HIGH\MEDIUM\
LOW.
BRIGHTNESS: Use the left/right direction key to move the scroll and
adjust the brightness.
CONTRAST: Use the left/right direction key to move the scroll and adjust
4060.indd 8 4060.indd 8 23.10.2006 9:25:13 23.10.2006 9:25:13