Vitek VT-4060 SR - Manual (Page 5)

ENGLISH
5
2. When other remote controls are used nearby or when the remote is
used near equipment using infrared rays, interference may occur.
3. Placing an object on the remote control may cause it to inadvertently
depress a button, changing a function and shortening battery life.
4. Make sure there is no barrier between the remote control and
remote sensor, as it could prevent the unit from receiving the signal.
5. Do not spill water or put wet items on the remote control.
6. Never disassemble remote control.
BATTERIES
INCORRECT USE OF BATTERIES MAY CAUSE THEM TO LEAK,
CORRODE OR EXPLODE.
1. STANDBY
2. GOTO
3. SETUP
4. PLAY/PAUSE
5. FAST FORWARD
6. VOLUME +/
7. FAST BACKWARD
8. TITLE
9. UP
10. LEFT
11. ENTER
12. AUDIO
13. DOWN
14. A MODE
15. PROG
16. OSD
17. S.EFFECT
18. L/R/ST
19. REPEAT
20. A B REPEAT
21. OPEN/CLOSE
22. NUMBER KEY
23. MUTE
24. NEXT
25. PREVIOUS
26. SUBTITLE
27. RIGHT
28. MENU
29. V MODE
30. ANGLE
31. SOURCE
32. TONE
33. CH LEVEL
34. ZOOM
35. STOP
36. STEP
Connection
Connection terminals for this DVD receiver are found on the rear panel.
Read carefully and follow the manufacture instructions of any video and
audio device being connected to this unit.
•
Not connect the power until all connections have been properly
completed.
• Red terminal (marked R) is for connecting the right channel. The
white terminal (marked L) is for connecting the left channel. The
yellow terminal is for video connection. Make sure all connections
are securely made. Improper connections may cause noise, poor
performance, or cause damage to the equipment. An not tie the AV
cord with any other cords, such as the power cord or speaker wires,
as it may result in poor picture and/or sound quality.
Stereo Audio
•
Use a pair of cable (red for right /white for left) to connect the stereo
audio output terminal of this unit to the other stereo audio input
terminal.
Coaxial Digital Audio
•
Use the coaxial cable to connect the coaxial output terminal of this
unit to the coaxial input terminal of power amplifier.
Speaker Output
•
Use the speaker cable to connect the speaker output of this unit to
the speakers' corresponding terminals.
Note: The physical connection should come with audio output setup of
this unit. Please refer to Audio Setup in System Setup.
4060.indd 5 4060.indd 5 23.10.2006 9:25:12 23.10.2006 9:25:12