Vitek VT-4060 SR - Manual (Page 4)

ENGLISH
4
Storing
Do not store discs in places subject to direct sunlight or near heat sources.
Do not store discs in places subject to moisture and dust.
Store discs vertically in a case. Stacking or placing objects on discs outside of their case may cause warping.
Handing and Caring for Discs Step:
FRONT PANEL
1. Power
2. DVD Door
3. Open/Close Button 4. Play/Pause Button
5. Stop Button
6. Mic Volume
7. Mic Jack
8. Volume Knob
REAR PANEL
1. Speaker Output Terminals
2 . 2CH Audio Input
3 . Video Output Jack
4 . S Video Output Jack 5. 2CH Audio Output
6 . Component Y, Cb/Pb, Cr/Pr
7. Coaxial
Output Jack
8 . FM Antenna Jack
9. VGA Jack
10. AM Antenna Jack
11. Scart Jack
Remote control
OPERATING THE REMOTE CONTROL
Battery installation:
1. Push down and out on the battery Compartment cover to remove it.
2. Insert the two AAA batteries into the battery compartment of the remote control, and making sure the + and signs on the batteries and inside the
battery compartment match up.
3. Replace the battery compartment cover.
Notes:
1. Do not mix batteries from different manufacturers, nor old ones with new.
2. If the remote control will not be used for an extended period of time, remove the batteries to prevent damage causing corrosion.
3. Remove dead batteries immediately to prevent damage causing corrosion.
4. If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace both batteries.
5. Always replace both batteries at the same time, using new, fully charged batteries.
6. Life expectancy of batteries may vary depending on amount of use.
Using the Remote Control
Point the remote control at the remote sensor on the DVD receiver. When the signal is received from the remote, the unit will function accordingly.
There mote will operate to approximately 16 from the remote sensor at an angle of around 30 degrees each direction.
Notes:
1. Do not direct the remote sensor toward any light source, such as direct sunlight or a strong fluorescent light, as it may cause the unit to not
operate correctly.
4060.indd 4 4060.indd 4 23.10.2006 9:25:11 23.10.2006 9:25:11