Garmin G1000 Quest Kodiak - Manual (Page 39)

SYSTEM OVERVIEW
1-29 190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
GPS CDI
The GPS CDI Box on the System Setup Page allows the pilot to define the range for the on-screen Course
Deviation Indicator (CDI). The range values represent full range deflection for the CDI to either side. The
default setting is ‘AUTO’. At this setting, leaving the departure airport the CDI range is set to 1.0 nm and
gradually ramps up to 5 nm beyond 30 nm from the departure airport. The CDI range is set to 5.0 nautical
miles during the enroute phase of flight. Within 30 nm of the destination airport, the CDI range gradually
ramps down to 1.0 nm (terminal area). During approach operations, the CDI range ramps down even
further to 0.3 nm. This transition normally occurs within 2.0 nm of the final approach fix (FAF).
If a lower CDI range setting is selected (i.e., 1.0 or 0.3 nm), the higher range settings are not selected
during any phase of flight. For example, if 1.0 nm is selected, the G1000 uses this for enroute and terminal
phases and ramps down to 0.3 nm during an approach. Note that the Receiver Autonomous Integrity
Monitoring (RAIM) protection limits follow the selected CDI range and corresponding flight phases.
The GPS CDI Box on the System Setup Page displays the following:
• Selected CDI range (AUTO, 5 nm, 1 nm, 0.3 nm)
• Current system CDI range (5 nm, 1 nm, 0.3 nm)
• ILS CDI capture mode setting (AUTO, MANUAL)
Changing the CDI range:
1) Use the FMS knob to select the System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the selected field in the GPS CDI Box.
4) Turn the small FMS Knob to highlight the desired selection from the range list.
5) Press the ENT Key.
Changing the ILS CDI capture setting:
1) Use the FMS knob to select the System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the ILS CDI capture field in the GPS CDI Box.
4) Turn the small FMS Knob to select the desired mode.
5) Press the ENT Key.