Audio panel and cns – Garmin G1000 Quest Kodiak User Manual
Page 81
190-00590-00 Rev. C
Garmin G1000 Pilot’s Guide for the Quest Kodiak 100
4-5
AUDIO PANEL AND CNS
6
COM3 – Not used in Kodiak 100 aircraft.
7
COM 1/2 – Not used in Kodiak 100 aircraft
.
8
TEL – Not used in Kodiak 100 aircraft.
9
PA – Selects the passenger address system. The selected COM transmitter is deselected when the PA Key
is pressed.
10
SPKR – Selects and deselects the cabin speaker. COM and NAV receiver audio can be heard on the
speaker.
11
MKR/MUTE – Selects marker beacon receiver audio. Mutes the currently received marker beacon receiver
audio. Unmutes automatically when new marker beacon audio is received. Also, stops play of recorded
COM audio.
12
HI SENS – Press to increase marker beacon receiver sensitivity. Press again to return to low sensitivity.
13
DME – Not used in Kodiak 100 aircraft.
14
NAV1 – When selected, audio from the #1 NAV receiver can be heard.
15
ADF – Not used in Kodiak 100 aircraft.
16
NAV2 – When selected, audio from the #2 NAV receiver can be heard.
17
AUX – Not used in Kodiak 100 aircraft.
18
MAN SQ – Enables manual squelch for the intercom. When active, press the PILOT Knob to illuminate
‘SQ’. Turn the PILOT/PASS Knobs to adjust squelch.
19
PLAY – Press once to play the last recorded COM audio. Press again while audio is playing and the
previous block of recorded audio will be played. Each subsequent press plays each previously recorded
block. Pressing the MKR/MUTE Key during play of a memory block stops play.
20
PILOT – Selects and deselects the pilot intercom isolation.
21
COPLT – Selects and deselects the copilot intercom isolation.
22
PILOT Knob – Press to switch between volume and squelch control as indicated by illumination of ‘VOL’
or ‘SQ’ . Turn to adjust intercom volume or squelch. The MAN SQ Key must be selected to allow squelch
adjustment.
23
PASS Knob – Turn to adjust Copilot/Passenger intercom volume or squelch. The MAN SQ Key must be
selected to allow squelch adjustment.
24
Display Backup Button – Manually selects Reversionary Mode.