Garmin G1000 Quest Kodiak - Manual (Page 71)

190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 3-3
ENGINE INDICATION SYSTEM
1 Torque Gauge
(TRQ FT-LB)
Displays engine torque in foot-pounds (ft-lb)
Caution and warning ranges are propeller speed sensitive and change for
speeds greater than 2000 rpm.
2 Interstage Turbine
Temperature Gauge
(ITT °C)
Displays Interstage Turbine Temperature (ITT) in degrees Celsius (°C)
Operating ranges differ for engine off and start conditions (see Figure 3-3).
When the starter is engaged, ‘STRT’ is annunciated above the temperature
readout. When the engine is off or in the process of being shut down,
‘OFF’ is annunciated.
3 Propeller Speed Gauge
(NP RPM)
Displays propeller speed in revolutions per minute (rpm)
4 Generator Speed Gauge
(NG %)
Displays gas generator speed as a percentage
5 Fuel Flow
(FFLOW PPH)
Displays current fuel flow in pounds per hour (pph)
6 Oil Pressure Indicator
(OIL PRES)
Displays engine oil pressure in pounds per square inch (psi)
7 Oil Temperature Indicator
(OIL °C)
Displays engine oil temperature in °C
8 Ammeter
(AMPS)
Displays DC current in amperes (amps) for the generator (G) and the
alternator (A)
9 Voltmeter
(VOLTS)
Displays DC bus voltages
10 Fuel Quantity Indicator
(FUEL QTY)
Displays quantities of fuel in pounds (lb) in the left (L) and right (R) tanks
11 Aileron and Rudder Trim
Bars (AIL, RUD)
Aileron and rudder trim are indicated with pointers along slide bars; the
white bars indicate takeoff trim positions
12 Elevator Trim Bar
(ELEV)
Elevator trim is indicated with a pointer along a slide bar; takeoff trim position
is indicated with a white bar and T/O label
13 Flap Position Indicator
(FLAPS)
Flap deflection is indicated with a pointer along a color-coded slide bar
Engine Off
Figure 3-3 Interstage Turbine Temperature Gauge Status Annunciations
Normal Engine Start