Garmin G1000 Quest Kodiak - Manual (Page 49)

190-00590-00 Rev. C Garmin G1000 Pilot’s Guide for the Quest Kodiak 100 2-5
FLIGHT INSTRUMENTS
Vspeeds (V
ref
and V
climb
) can be changed and their flags turned on/off from the Timer/References Window.
When active (on), the Vspeeds are displayed at their respective locations to the right of the airspeed scale. By
default, all Vspeed values are reset and all flags turned off when power is cycled.
Changing Vspeeds and turning Vspeed flags on/off:
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to highlight the field of the desired Vspeed to be changed.
3) Use the FMS Knob to enter the desired speed and press the ENT Key (when a speed has been changed from a
default value, an asterisk appears next to the speed).
4) With the flag ON/OFF field highlighted, turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
5) To remove the window, press the CLR Key or the TMR/REF Softkey.
Figure 2-6 Timer/References Menu
Figure 2-5 Timer/References Window
Turning all Vspeed flags on/off:
1) Press the TMR/REF Softkey.
2) Press the MENU Key.
3) To activate all Vspeed flags, press the ENT Key with ‘All References On’ highlighted.
4) To remove all Vspeed flags, turn the FMS Knob to highlight ‘All References Off’ and press the ENT Key.
Restoring all Vspeed defaults:
1) Press the TMR/REF Softkey.
2) Press the MENU Key.
3) Turn the FMS Knob to highlight ‘Restore Defaults’ and press the ENT Key.