AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 28)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 28 (104)
3.2 Static local configuration of a RFP
As an alternative to DHCP configuration, the RFPs’/OMM may be individually
statically configured using the OM Configurator tool.
The OM Configurator requires the Java Runtime Environment version 1.6 or
higher.
The settings, which are configured on the RFP with the tool OM Configurator,
will be saved permanently in the internal flash memory of RFP.
The parameters configurable via the OM Configurator comply with the DHCP
option, please see section 3.1.4 for details.
If a local static configuration has been done, DHCP is not used anymore.
The following figure shows the OM Configurator.
On systems with multiple Ethernet adapters select the interface to use for the
configuration of the RFP’s.To configure a RFP, at least the MAC address and
all mandatory options (see table below) have to be set. The MAC address
must be entered in a format such as xx-xx-xx-xx-xx-xx.
If the RFP has already an IP address enter this address in the IP address
field. In this case you can reach the RFP from outside the local LAN
segment. Optional.
To set additional parameters, press the “Add parameter” button and choose
the desired parameter.