AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 84)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 84 (104)
7.3.5.3 RFP console commands
If you type “ ip_rfpconsole ” you are able to use the following commands on
each RFP:
heap - shows heap buffer statistics
help - Displays Command Help Table
lec - adjust linear echo canceler parameters
media - display state of media channels
mutex - lists all created MXP mutexes
queues - lists all created MXP queues
reset - resets the IPRFP application
rsx - allows RSX connection to BMC via TCP
sem - lists all created MXP semaphores
spy - set/display spy levels: [ <key #> <level #> ]
tasks - lists all running MXP tasks
voice - displays the state of voice handling
exit - leave the IP-RFP console
Note: The “ spy ” command enables you to increase the level of syslog
messages. This should be only used by instructions of the support
organization because it can harm the system operation.
7.3.5.4 OMM console commands
If you have opened the session on the OMM RFP and you type
“
ommconsole ” you are able to use the following OpenMobility Manager
(OMM) related commands:
[email protected] > ommconsole
Welcome to the omm console, use ? for a list of possible commands
omm# help
Command | Description
--------------------------------------------------------------------
-----------
? | Displays Command Help Table
cmi | cmi commands
cnf | Show configuration parameters
dsip | dsip commands
help | Displays Command Help Table
exit | leave this console
heartbeat | configure heartbeat mechanism for IP-RFPs
ipc | displays socket communication
ipl | displays configured RFPs
ki | KI Monitor
quit | leave this console
logger | send a string to the syslog daemon
mon | toggle monitor functionality
msm | display states within MediaStreamManagement
mutex | lists all created MXP mutexes
queues | lists all created MXP queues
rspy | remote configure spy levels on IP-RFPs
rsx | displays configured RFPs
sem | lists all created MXP semaphores
spy | set/display spy levels: [ <key #> <level #> ]
standby | displays redundant OMMs
sync | commands for RFP synchronisation